Adheflex adhesive parquet - white - 600 ml - Sika

Manufacturer: Sika
Be the first to review this product
Manufacturer part number: 183728
Vendor: Espace-Bricolage
€11.60
i h
Adhesive adhesive SIKA Adheflex Parquet - 600 ml, ideal for laying cords of tongue and groove parquet. It improves acoustic insulation against impact noise and limits the sound of glued parquet. Formulated without water, this glue does not cause swelling of the floor.
Products specifications
Package QTY1
Adhesive colourWhite
Size (L / ml / g / gal /oz)600ml
AdvantagesWithout water, does not cause swelling of the parquet fast and bubble-free polymerization suitable for most wood species improves sound insulation to shock and limits the sound of glued parquet suitable for gluing on old glued tile suitable for laying on low-temperature heating floors in combination with acouflex pc3 can be sanded characteristics: density: 1, 35 approx colours: brown parquet support temperature: greater than or equal to + 5 ° c when laying on a non-heated floor / from + 20 ° c approx. when laying on a heated floor polymerisation speed: approx. in 24 hours at + 23 ° c and 50% rh packaging: 600 ml reference: 183728 packaging: comes in original packaging advice: supports the substrate must be level, clean, healthy, normally porous. there must be no powder, no cracking or crust on the surface. the lack of flatness of the supports allowing to receive a glued floor must not be superior to: 1 mm of maximum deflection under the ruler of 20 cm / 5 mm of maximum deflection under a ruler of 2m. substrates that are too degraded will need to be rehabilitated (dead plaster, etc.).
ApplicationSika Adheflex Parquet is applied in parallel cords on prepared floor or on joists. The cords must be perpendicular to the length of the blades. Apply cords at least 6 mm in diameter. Make sure that the thickness of the cords is sufficient to compensate for spot defects in the flatness of the floor. On the joist, apply at least 2 cords along its entire length. Spacing of cords on prepared floor: spacing of 100 mm according to DTU 51.2 The installation of the parquet must be done by retreating before glue forms a skin (about 65 minutes at + 23 ° C and 50% RH), according to the prescriptions of its manufacturer and DTU 51.2 Crush the glue beads by manual pressure on the blades to a glue thickness of 1 to 2 mm maximum. If necessary, maintain the floor until the glue is completely dry. Use Sika products with care. Before use, please consult the manufacturer product leaflet available on the sika.fr website.
0 review(s)
0.0 0
Write your own review Close
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
*
*
*
Only registered users can write reviews