Adhesive for mortars and concretes - SIKA SiderLatex - Milky white - 5L

Manufacturer: Sika
Manufacturer part number: 72049
GTIN: 7612894258813
€45.06
i h
Adhesive for mortars and concretes - SIKA SiderLatex - Milky white - 5L, Copolymerized resin emulsion, sider Latex is compatible with all cements, lime and plaster. Advantages : Significantly improves the adhesion of the mortar on all surfaces, even smooth ones Hanging mortars on old substrates, plasters and plaster Increases the plasticity of mortars and facilitates their implementation Improves the modulus of elasticity of mortars, resulting in improved crack resistance Reduces wear and dust Improves waterproofing, improves waterproofing and cohesion Enhances erosion resistance and thus provides better durability of stabilized and compacted mortars used, for example, in reinforced pavements on pedestrian paths, bicycle paths or parking areas. Features : Density: about 1 Shelf life: 1 year in its original packaging intact or opened Storage conditions: Protected from freezing and excessive heat Consumption: As a tack coat; 0.1 L / m / mm thick and as a mortar: 0.6 L / m / cm thick Colour: milky white Conditioning: 5 litres Reference: 72049 Packaging : 1x Recovery adhesive for mortars and concretes - SIKA SiderLatex - Milky white - 5L Delivered in its original packaging Tips : Preparation of the Sider Latex solution: 1 volume of Sider Latex + 3 volumes of water. Preparation of gobetis: 1 part cement + 0.5 to 1 part sand. Mix with Sider Latex solution until desired consistency is achieved. Application of the gobetis: Allow the support to bleed and throw the resulting gobetis on the wall. Let the gobetis pull out and then apply the coating that can be added with Sider Latex (1 volume of latex + 5 volumes of water). For best results, make the top coat Preparation of a slip: 1 part cement + 1 to 2 parts sand. Mix with Sider Latex solution to the desired consistency Application of slip: On damp soil but without puddles, spread the slip with a broom. On the still sticky slip, make the screed which can be added with Sider Latex for an optimal result. Masonry joints: If necessary, push the joints back to a depth of a few centimetres. Wash them with a pressurized water jet. Fill the joints still wet then apply the plaster which can be added with Sider Latex (1 volume of Latex + 5 volumes of water) Ragrages, repairs: Impregnate the part to be repaired with the Sider Latex solution. Apply and tighten the mortar with Sider Latex Surfacing: On the surface of the concrete, spray the Sider Latex solution. Then sprinkle a dry mixture of fine sand and cement (50/50) and tallow.
0.0 0
Write your own review Close
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
*
*
*
Only registered users can write reviews