All-tile tile adhesive interior and exterior (C2-ET) - SIKA SikaCeram Xtra - White - 25kg

All-tile adhesive for interior and exterior (C2-ET) tiles - SIKA SikaCeram Xtra - White - 25kg, is a very low-dusting tile adhesive which can be used on interior floors and walls and only in exterior areas with a maximum size of 60cm x 60cm (3600 cm) in floors and 45cm x 45cm (2025 cm) in walls. Advantages : Very low dust emission during the preparation of the mixture. Adhesive mortar classified C2-ET. Suitable for interior floors and walls and only for exterior floors. Suitable for use on concrete substrates, paving, screed, cement-based coatings, cellular concrete, anhydrite screed, wood panels, old tiles in interiors, old linoleum or PVC flooring, SikaLastic 850W, cement coatings and concrete in swimming pool basins. Features : Maximum tile size: 60cm x 60cm (3600 cm) for floor and 45cm x 45cm (2025 cm) for walls Operating temperatures: + 5 to + 30C (product, environment, support) Curing time: 3 min Maximum glue thickness: 10 mm Practical operating time: 3 hours (at +23C, 50% RH) Open time: 30 min (at +23C, 50% RH) Adjustment time: approx. 20 min (at +23C, 50% RH) Time before grouting: minimum 12 hours at +23C Putting back into service: time after grouting (depending on temperature conditions and the grouting product used): 24 to 36 hours (pedestrian traffic) Delay for pool impounding: 21 days Colour : White Packaging : 25kg Reference : 461420 Packaging : 1x All-tile tile adhesive interior and exterior (C2-ET) - SIKA SikaCeram Xtra - White - 25kg Delivered in its original packaging Tips : The substrate is prepared in such a way as to be clean, sound, free of dust and loose parts that are not adherent or that could impair adhesion. In particular, it must be free of traces of release agents, curing agents, grease, laitance, plaster, etc., and must be free of all traces of mould release agents, curing agents, grease, laitance, plaster, etc., on the surface. The support is moistened beforehand if necessary (application on a very absorbent support or one that has been exposed to the sun, in hot weather). The substrate must not be damp and must be free of any film or puddle on the surface during application. Stir with clean water to desired consistency using an electric mixer at low speed (about 500 rpm) until a homogeneous paste is obtained without lumps. Mixing rate: approximately 28%, i.e. 6 litres of water per 25 kg bag, and 1.2 litres of water per 5 kg bag. Curing time: 3 min. Prepare in advance only the quantity of product that can be used, taking into account the practical duration of use, open time, ambient conditions and the speed at which the flooring is to be laid. Spread the adhesive mortar on the substrate using a trowel or smoothing machine, then adjust the thickness with a notched spatula (choice of teeth according to the size of the covering and the flatness of the substrate; (see product instructions). In the case of double gluing, coat the back of the element to be glued with a thin layer of adhesive mortar (1 to 2 mm). Maximum glue thickness: 10 mm. Within the limit of the open time, lay the covering on the glued substrate and press it strongly or beat it so as to expel the air and obtain a good transfer of the adhesive mortar. Sponge clean the coating as soon as it is put in place. Make the joints using SikaCeram Joint Fine, Large or Flex.