Bituminous waterproofing coating for roadbeds - SIKA Igolatex - Black - 25kg

Bituminous waterproofing coating for roadbeds - SIKA Igolatex - Black - 25kg to protect concrete and acts effectively against chemical aggression. Advantages : Can be applied directly on porous substrates: agglos, cinder blocks or aerated concrete blocks. Easy application with a trowel Adheres to concrete, mortar, stone, brick, wood? Does not flutter Do not earthenware Forms an impermeable coating after drying Ready to use Compatible with CPA-CEM I and CPJ-CEM II cements for use in mortars Features : Density: Approximately 1 Dry matter content by weight: 47 to 53%. Application temperature: between + 5 C and + 30 C Consumption: varies according to the roughness of the substrate. As an indication: from 1.0 kg/m to 2.5 kg/m for the 2 coats. Colour: Black Packaging : 25kg Reference : 164905 Packaging : 1x Bituminous waterproofing coating for roadbeds - SIKA Igolatex - Black - 25kg Delivered in its original packaging Tips : The supports will be at least 10 days old. Substrates must be clean, sound and free of loose parts. In particular, they shall be free from traces of oil, grease, etc., and shall be free from any kind of contamination. Porous surfaces should be moistened beforehand. Gravel nests must be levelled with a mortar from the Sika Monotop or SikaTop range. The masonry will be carefully repointed using a mortar from the Sika Monotop or SikaTop range. The Igolatex covering is made at least 15 cm above the finished level of the exterior floor. Igolatex is applied with a notched trowel in 2 layers by tightening them tightly. The first layer is applied from bottom to top with the notched side of the float. The second coat, applied with the smooth side of the float, fills and covers the grooves left by the first coat. Apply the second coat in the same direction as the first, so as not to trap air between the two coats. Wait for the first coat to harden before applying the next one, i.e. about 1 to 4 hours at + 20C depending on the ambient humidity. The total thickness of the coating must not exceed 3 to 4 mm, with a minimum of 2 mm at any point, in order to obtain a correct drying. Use Sika products with care. Before use, please refer to the manufacturer's product manual available on the sika.co.uk website.