Colle Saderprene DI-contained hardener

Saderprene versatile DI adhesive for bonding: Rubber, leather, cork, wood, flexible foams, polyether polyurethane, felt them and on different media: wood, metal, cement, also for bonding soles or smooth for walls alveolar. Is used for the plating of decorative laminates rigid supports (chipboard, wood ....) .Ne not suited for bonding expanded polystyrene or plasticized PVC. Features: Color: amber Density: about 0.85 Solids: about 23% Viscosity: 3000 mPa.s minimum temperature: 15 C Drying time at 20 C: 10 to 20 mn Benefits: ready Bonds employment in a solvent medium. Without without toluene and cyclohexane. low odor without settling. Long open time. Excellent heat resistance. Use double gluing the notched trowel or brush. Instant decision, requiring no frame clamp or press. Tips: The drying time is respected (variable time depending on temperature, humidity and porosity of materials to be bonded), get glued surfaces in contact in taking care to align the two surfaces, and place the coating on the carrier so as to evacuate the air. Do not exceed the open time of the adhesive. SIZING Using a trowel A4 Bell or brush, spread a regular layer of adhesive on each side of the material to stick (to the coating and substrate) at about 140 to 160 g / m .DES solvent evaporation (drying time: about 15 minutes), the adhesive must leave a slightly shiny continuous film in oblique light, should not "hang" the finger, but be sticky. TIGHTENING Taking being instantaneous, it is not necessary to have press or clamp. Exert an even pressure over the entire surface starting with the recent, in marouflant by means of a rubber roller. STABILIZATION Leave collages to stabilize for at least 4 hours. The maximum sticking force is obtained after 6 to 8 days at 23 C. Use Sader products safely. Before use, read the label and product information.