Glue Gel Saderprene held high heat does not flow

Manufacturer: Sader
Manufacturer part number: SADERPRENE GEL 5KG
GTIN: 3184410229415
€74.20
i h
Colle Saderprene held high heat Gel does not flow, bonding laminates, laminates, polyester, cork, rubber, metal, paper, lead, textile, glass wool, cardboard, among themselves and on wood panels, cons-plated and particles, concrete, plaster. Not suitable for bonding polystyrene. Specifications Appearance: Gel Color: yellow Density: about 0.85 Dry extract: 24% envrion Advantages: Colle ready for Solvent-employment. Without without toluene and cyclohexane. low odor without settling. Long open time. Excellent heat resistance. Use double gluing the notched trowel or brush. Instant decision, requiring no frame clamp or press. Tips: The drying time is respected (variable time depending on temperature, humidity and porosity of materials to be bonded), get glued surfaces in contact in taking care to align the two surfaces, and place the coating on the carrier so as to evacuate the air. Do not exceed the open time of the adhesive. SIZING Using a trowel A4 Bell or brush, spread an even layer on each side of the material to stick (to the coating and substrate) at about 140 to 160 g / m. Upon evaporation of the solvents (drying time: about 10 minutes), the adhesive must leave a slightly shiny continuous film in oblique light, should not "hang" the finger, but be sticky. TIGHTENING Taking being instantaneous, it is not necessary to have press or clamp. Exert an even pressure over the entire surface starting from the center, in marouflant by means of a rubber roller. STABILIZATION Leave collages to stabilize for at least 4 hours. The maximum sticking force is obtained after 6 to 8 days at 23 C. . Use Sader products safely. Before use, read the label and product information.
0.0 0
Write your own review Close
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
*
*
*
Only registered users can write reviews