Spray paint Plasti Dip Blue Phosphorescent 400 ml, color phosphorescent you! The Plasti Dip is an ultra resistant liquid elastomer coating. Flexible, flexible, and resistant, it does not crack, does not crack and provides adhesion. It resists mildew, small impact, scratch and scratch, abrasion, sea water, weathering, electrical arcing, corrosion and even Karcher! It applies in all media without any preparation other than a degreasing. It air dries in 30 minutes and can be removed easily without any trace and damage to paints and varnishes. Application: Plasti Dip is used to cover, decorate, protect, seal, identify, isolate acoustically and electrically seal ... in very diverse sectors such as aeronautics, automotive, watches, etc. Directions: Shake vigorously for at least 1 minutes when the ball starts moving Spray the surface to be treated in a back and forth at a distance of 20 to 30 cm Wait at least 30 minutes between each layer apply as many layer as needed (a minimum of 3 coats recommended) Wait at least 4 hours to complete drying Directions: Hide possibly the parties to protect use the aerosol dry sheltered from the wind in a well ventilated place Keep the spray in a dry place Do not use aerosol for the intended use We recommend you start with a black undercoat Features: Color: blue Finish: matt Packaging: spray Volume: 400 ml Power Coverage: 3m Opacity (tested with black) reached with 4 layers, slip-resistant Power: excellent tensile strength (ASTM D-638 2.6 daN / m): excellent elongation (ASTM D-638): 430% Resistance cut (according to ASTM D-1044): excellent Abrasion stone: excellent chemical resistance to acids, alkaline products, sea water, chlorine-based solutions or caustic ammonia: excellent chemical resistant to oil powers and acetone: low insulating properties in accordance with ASTM D-149: 1200 V / mm Operating temperature: -34 C to + 93 C shore A hardness (ASTM D-2240): 70 Viscosity at 25 : 80 to 100 Krebs Units resistance to salt spray (ASTM B-117): more than 1000 hours weather resistance (ASTM G-53): 7-10 years permeability dust (according to ASTM E-96): 0.03 grains / square foot / time Use the Plasti Dip products safely. Before use, read the label and product information.