polyurethane adhesive glue 310ml ISOLEMFI 3300 thane polyurea-component polyme risant by the action of moisture .The movie polyme rise??????? pre? feel a be? s strong performance has? heat and excellent re? resistance was? ? Water translucent gel, solvent, can be painted after drying Usage: This adhesive gel s used for bonding various insulation (expanded or extruded polystyrene, polyurethane foam, phenolic foam, mineral wool boards) wood, chipboard ?, plasterboard, concrete or stone for matt hard mate- including me rate, polyester, PVC, it is not necessary to make pre tests alables Features:? Adhesive polyurethane Color: Milky density DIN 52 451: 1, 07 skin formation: 10 to 15 minutes pressing time: about 1 hour setting time: 30 minutes temperature of implementation: + 5 C and + 65 C temperature resistance: - 30 C to + 100 C Advantages: water resistance: certified class D4 according to EN 204 Good resistance to UV Gel without solvents great Smoothing Can be painted after drying Tips: SUPPORTS They must be e Plans, dry, without re Poussie,? grease or other contaminants that could harm bonding USER ISOLEMFI 3300? s apply simple sizing cords through? a gun? cartridges or? the doctor in the case of two non-absorbent substrates, a pulve? authorization? s water is? required (10 to? 15 g to 100 g glue) To exercise the maximum possible pressure without? trained mate? rials school? irre it? reversible. ? The time taken depends on the sorts hygroma and temple room temperature is therefore impe ratif: -???? If work? a temple? infe temperature? is higher? 20 C to ensure that s pressing time is enough - if work? a temple? supe temperature? is higher? 20 C? S sure that open time and closed assembly time? before pressurization are not excessive; otherwise collages? s defective could? ensue Clean tools with me? Thyle? thylce? or the tone? ace? tone before the glue is polyme? rise? e. After? S polyme? Authorization,? S abrasion is? EMFI necessary Use the products safely. Before use, read the label and product information.