polyurethane adhesive ISOLEMFI 3300 310ml X 5

Manufacturer: Emfi
Manufacturer part number: 3300/CCHE X5
GTIN: 3700812003172
€52.50
i h
polyurethane adhesive ISOLEMFI 3300 310ml X 5 thane polyurea-component adhesive polyme risant by the action of moisture .The movie polyme rise??????? pre? feel a be? s strong performance has? heat and excellent re? resistance was? ? Water translucent gel, solvent, can be painted after drying Usage: This adhesive gel s used for bonding insulating diffe ent (polystyre only expands or extruded ?, polyurea foam thane foam phe nolique????? mine wool panels? rale) on wood, agglome? re? s pla panels master, be? tone or stone for mate? difficult rials, including me? rate, polyester, PVC, it is not? necessary to make pre trials alables Features: polyurethane adhesive Colour: Milky density DIN 52 451 1.07 skin formation: 10 to 15 minutes pressing time: about 1 hour setting time: 30 minutes Temperature of implementation: 5 C and + 65 C temperature resistance: - 30 C to + 100 C Advantages: water resistance: certified class D4 according to EN 204 Good resistance to UV Gel Smoothing without solvents can be great painted after drying Tips:??? SUPPORTS They must be e Plans, dry, without re Poussie, grease or other contaminants that could harm bonding USER ISOLEMFI 3300 s apply simple sizing cords using a gun? at? cartridges or? the doctor in the case of two non-absorbent substrates, a pulve? authorization? s water is? required (10 to? 15 g to 100 g glue) To exercise the maximum possible pressure without? trained mate? rials school? irre it? reversible. ? The time taken depends on the sorts hygroma and temple room temperature is therefore impe ratif: -???? If work? a temple? infe temperature? is higher? 20 C to ensure that s pressing time is enough - if work? a temple? supe temperature? is higher? 20 C? S sure that open time and closed assembly time? before pressurization are not excessive; otherwise collages? s defective could? ensue Clean tools with me? Thyle? thylce? or the tone? ace? tone before the glue is polyme? rise? e. After? S polyme? Authorization,? S abrasion is? EMFI necessary Use the products safely. Before use, read the label and product information.
0.0 0
Write your own review Close
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
*
*
*
Only registered users can write reviews