Sader R.22 vinyl adhesive for assembling and plating all species slow 750g decision

vinyl adhesive Sader R.22 for assembly and plating all species slow 750g plug, ready for use. Work on clean, dry and flat. wood assembly, veneer laminates for cold and hot on particle board. Features: vinyl adhesive Sader R.22 Contents: 750g Ready to use Base: polyvinyl acetate emulsion Solids: about 36% pH: about 4.5 Movie: opaque white. Translucent maximum after drying Open time at 20 C: 30 minutes, depending on porosity of the media minimum temperature range: + 8 C Advantages: emulsion adhesive ready to use, open-flammable long time does not stain Nontoxic N abyss not sharp tools Excellent resistance to tearing temperature resistance up to 70 C Tips: Paste ready to use, mix well before use. Control the workshop temperature before application of the adhesive. It should ideally be between 18 and 25 C. Vinyl adhesives are emulsions in water. They did not by taken if one of the two materials at least is absorbent. MATERIALS The materials to be bonded must be dry, clean, dust, degreased. The humidity of the wood should be between 8 and 12% for interior furnishing works. Surfaces must be perfectly flat. The machining must be very precise to avoid thick joint (maximum set of 2 / 10th mm) may degrade bonding. DIRECTIONS FOR USE Apply the adhesive on the support thinly and evenly with a size, spatula, brush, etc. The application is made by gluing one or two sides depending on the porosity of the wood, the ambient conditions (temperature and humidity) and following that one wishes or not lengthen the time of the travail.Utilisez Sader products safely. Before use, read the label and product information.