Sader R.22 vinyl adhesive for assembling and plating all species slow decision 5Kg

vinyl adhesive Sader R.22 for assembly and plating all species slow setting, ready to emploi.Travaillez on clean, dry and planes.Assemblage wood, laminated veneer cold and hot on chipboard . Features: Base: Solids polyvinyl acetate emulsion: about 36% pH: about 4.5 Movie: opaque white. Translucent maximum after drying Open time at 20 C: 30 minutes, depending on substrate porosity Minimum Operating Temperature: + 8 C Advantages: adhesive emulsion, ready for use, with long open time, non-flammable, does not stain . Nontoxic. Does not damage the cutting tools. Excellent resistance to tearing. temperature resistant to 70 C. Tips: Paste ready to use, mix well before use. Control the workshop temperature before application of the adhesive. It should ideally be between 18 and 25 C. Vinyl adhesives are emulsions in water. They did not by taken if one of the two materials at least is absorbent. The materials to be bonded must be dry, clean, dust, degreased. The humidity of the wood should be between 8 and 12% for interior furnishing works. Surfaces must be perfectly flat. The machining must be very precise to avoid thick joint (maximum set of 2 / 10th mm) may degrade bonding. Apply glue to the support thinly and evenly with a size, spatula, brush, etc. The application is made by gluing one or two sides depending on the porosity of the wood, the ambient conditions (temperature and humidity) and following that one wishes or not lengthen the time of the travail.Utilisez Sader products safely. Before use, read the label and product information.