Sader R.41 vinyl adhesive assembly and plating fast setting 5Kg

vinyl adhesive Sader R.41 assembly and plating 5kg fast setting, excellent resistance to moisture, recommended for carpentry work, kitchen units, bathrooms, interior layout bateaux.Travaillez on clean, dry planes.Assemblage and wood veneer laminated cold and hot on particle board. Features: Base: Solids polyvinyl acetate emulsion: approximately 51% chalk point: + 5 C pH: about 3 Movie: White opaque - translucent after drying Open time at 20 C: 4-8 minutes Advantages: Resistance moisture (ranking D3 as EN 204-205). Adhesive emulsion ready to use, non-flammable, does not stain. Nontoxic. Does not damage the cutting tools. Excellent resistance to tearing. temperature resistant to 70 C. Tips: Paste ready to use, mix well before use. Control the workshop temperature before application of the adhesive. It should ideally be between 18 and 25 C. Vinyl adhesives are emulsions in water. They did not by taken if one of the two materials at least is absorbent. SUPPORTS To avoid the appearance of tensions in the glue lines, media must have such humidity after bonding, it is as close as possible to that they will once commissioned. Surfaces must be perfectly flat and clean. Assemblies must be precise to avoid the thick joints (2 / 10th mm maximum). SIZING Apply glue to the support thinly and evenly with a size, spatula, brush, etc. For assembly, a double-sided gluing is preferable. To obtain intimate contact between the adhesive and the brackets with a glue joint of the order of 1 / 10th of mm, it is necessary to securely fasten assemblages. The clamping time is the time necessary for the dissolution water to be evaporated or absorbed by the media. It may vary depending on the porosity of the media, type of wood, room temperature, deposited weight, etc. A preliminary test to determine the exact. Use Sader products safely. Before use, read the label and product information.