SIKA Adheflex Spatulable Flexible Glue i-Eco - 3 x 6kg

SIHE Adheflex Flexible Adhesive Spatulable i-Eco - 3 x 6kg, a fast and solvent-free polymerization applicable to the notched spatula for all parquet gluing jobs. This flexible glue will increase the sound insulation to impact noise and limit the sound of glued parquet. Characteristics: Density: 1,29 approx. Color: brown parquet Support temperature: Greater than + 5 C when laying on a non-heated floor / From + 20 C maximum when laying on a heated floor Curing rate: approx. in 24 hours at + 23 C and 50% RH With toothed spatula B6: Consumption: 700 to 900 g / m approximately / With toothed spatula B11: Consumption: 800 to 1000 g / m Packaging: 3 x 6kg Reference: 421804 Advantages : Known packaging that facilitates processing, minimizes construction losses and facilitates waste disposal Solvent-free and low odor Single-component glue i-Cure Fast curing Improves sound insulation to impact noises and limits sound of glued parquet Suitable for most types of wood Suitable for gluing on old tiled floors and on calcium sulphate screeds Can be sanded Very low VOC emissions Advice: SUPPORTS Support must be level, clean, healthy, normally porous. There must be no powder, no cracking or crust on the surface. The lack of flatness of the supports allowing to receive a glued floor must not be superior to: 1 mm of maximum deflection under the ruler of 20 cm / 5 mm of maximum deflection under a ruler of 2m. APPLICATION Sika Adheflex Spatulable ECO should be applied directly from the bag and distributed evenly using the notched spatula suitable for the floor, over the entire surface of the carefully prepared surface. Cut a corner of the bag and pour the product into the dish. ground. Then divide the glue in a continuous layer with the notched spatula held perpendicular to the ground and work backwards. For a good comfort of installation, the width of the glued surface can be about 0,5 m The laying of the parquet is done before the glue forms a skin (90 minutes at + 23 C and 50% RH) . Otherwise, remove the glue that has formed a skin using a plaster knife or other. In case of lack, reapply glue Thoroughly rub the parquet boards in the glue so as to get a good wetting over their entire length. The blades can then be tightened with a mallet and an intermediate piece. The floors must be laid in accordance with the DTU 51.2 and the requirements of the parquet manufacturer (moisture content, peripheral joints, joints between blades, etc.) Close the bag tightly and quickly after use, chasing the air and then folding it on itself Use Sika products with care. Before use, please consult the manufacturer's product leaflet available on the sika.fr website.