SIKA Sikagard Poolcoat pool cover - Blue - 10L

SIKA Sikagard Poolcoat pool cover - Blue - 10L, with a very good resistance to water and pool treatments, this acrylic resin offers a very good protection to concrete pools and pools and mortar where the treatment is done by chlorination only. Advantages: Very good color stability A product that is very resistant to aging with a very low tendency to chalking Has a very good resistance to water, sea water and pool treatment products Very good resistance to sunscreen oilsEasy cleaning and disinfection Spacer maintenance operation For pools with chlorination treatment Characteristics: Density: about 1.3 Application temperature: 8 C min to + 30 C max Drying time: At least 14 days drying after the last coat and ensure sufficient ventilation every day. Consumption: about 0.130 liter / m per layer depending on the substrate. New works: 2-3 layers in renovation: 1-2 layers Color: Blue Packaging: Bucket 10L Reference: 86667 Packaging: Comes in its original packaging Advice: SUPPORT Concrete support / cement mortar: Prepare carefully the whole of the surface with a jet of compressed air to remove loose particles. The milt must be removed by a suitable mechanical preparation. In the presence of soft or poorly cohesive support, sand or sand, and then dust off thoroughly by suction or by cleaning with water under pressure. The cavities must be repaired using a suitable mortar from the SikaTop range. If necessary, use a smoothing or leveling compound to ensure a good surface regularity and seal the porosity of the concrete, in order to prevent the risk of blistering of the coating. Old coatings: In the case of chlorinated rubber coating adhering well, carry out a careful cleaning to remove all traces of limestone, dirt, oil. Then proceed to a light sanding to create a micro-roughness, then dust off. In the case of an existing, well-adherent coating of the Sikagard PoolCoat type, a simple cleaning with pressurized water (100 to 150 bar, possibly using a suitable cleaner) is sufficient. In case of doubt, a preliminary adhesion test is recommended. APPLICATION Apply Sikagard PoolCoat by roller, brush or spray gun (AIRLESS: 180 bar atomizing pressure, nozzle diameter 0.38-0.66 mm, spray angle 40-60 ). When applying the roller, to seal the porosity, make sure to penetrate the different layers by brushing later. Use Sika products with care. Before use, please consult the manufacturer's product leaflet available on the sika.fr website.