Special indoor tile adhesive new (C1) - SIKA SikaCeram Classic - Grey - 25kg

Special indoor tile adhesive for new tiles (C1) - SIKA SikaCeram Classic - Grey - 25kg, is a suitable tile adhesive for all types of indoor floor and wall tiles with a maximum size of 45cm x 45cm (2025cm). Advantages:? Normal adhesive mortar classified C1 Interior floor and wall use with all types of tiles Suitable for use on concrete substrates, paving, screed, cement-based plasters, terracotta tile walls and aerated concrete CE marked selo NF EN 12004 Features : Temperature of use: + 5 to + 30C (product, environment, support) Maximum glue thickness: 10 mm Practical operating time: 3 hours (at +23C, 50% RH) Open time: 20 min (at +23C, 50% RH) Adjustment time: approx. 20 min (at +23C, 50% RH) Time to seal: minimum 12 hours, depending on temperature conditions. Time after grouting (depending on temperature conditions and the grouting product used): 12 hours (pedestrian traffic) to 36 hours (normal room occupancy). Colour: Grey Packaging : 25kg Reference : 461248 Packaging : 1x Special indoor tile adhesive new (C1) - SIKA SikaCeram Classic - Grey - 25kg Delivered in its original packaging Tips : The substrate is prepared in such a way as to be clean, sound, free of dust and loose parts that are not adherent or that could impair adhesion. In particular, it must be free of traces of release agents, curing agents, grease, laitance, plaster, etc., and must be free of all traces of mould release agents, curing agents, grease, laitance, plaster, etc., on the surface. The support is moistened beforehand if necessary (application on a very absorbent support or one that has been exposed to the sun, in hot weather). The substrate must not be damp and must be free of any film or puddle on the surface during application. Pour the water into a bucket and add the product. Observe a ratio of 5.75 to 6 litres of water per 25 kg bag. Mix with an electric mixer at low speed (approx. 500 rpm) until a homogeneous paste is obtained without lumps. Let the mixture stand for 3 minutes. Stir the mixture quickly with a trowel and then start laying with the notched spatula. Prepare in advance only the quantity of product that can be used, taking into account the practical duration of use, open time, ambient conditions and the speed at which the flooring is to be laid. Spread the adhesive mortar on the substrate with a trowel or smoothing machine, then adjust the thickness with a notched spatula (choice of teeth according to the size of the covering and the flatness of the substrate (see product instructions). In the case of double gluing, coat the back of the element to be glued with a thin layer of adhesive mortar (1 to 2 mm). Maximum glue thickness: 10 mm. Within the limit of the open time, lay the covering on the glued substrate and press it strongly or beat it so as to expel the air and obtain a good transfer of the adhesive mortar. Clean the coating with a damp sponge as soon as it is laid. For the joints used SikaCeram Joint Thin, Wide or Flex.