The system combines a pure sine wave inverter with a sophisticated adaptive charging technology battery charger. Compatible with lithium batteries as well. Two AC outputs. In case of power outage from the shore or generator, the device switches to inverter mode to power the connected devices without interruption. The second output is only available when AC source is present. Devices that may drain

The system combines a pure sine wave inverter with a sophisticated adaptive charging technology battery charger. Compatible with lithium batteries as well. Two AC outputs. In case of power outage from the shore or generator, the device switches to inverter mode to power the connected devices without interruption. The second output is only available when AC source is present. Devices that may drain the battery, such as a boiler, should be connected to this output. Parallel + three-phase function. Up to 6 devices can be connected in parallel. It is possible to connect 3 units of the same type for three-phase current. Up to 6 sets of 3 units can be paralleled. Power control: the multiplus is very powerful and can absorb a lot of power from the shore or generator. With the multicontrol panel (14.270.32), the absorbed power can be controlled by setting a maximum limit. The multiplus, considering the set limit, will only use the remaining energy to charge the batteries. Power assist: in case of a short period of high power demand, the multiplus will compensate for insufficient supply by drawing energy from the battery. When the load decreases, the excess power is used to recharge the batteries. The microprocessor-controlled battery charger has a 4-stage charging system: bulk-absorption-float-storage, similar to the Phoenix/Skylla charger. - Aluminum casing - Protections against short circuit, overload, low or high battery, high ripple frequency, etc.