Tile adhesive for all tiles inside and outside (C2-ET-EG) - SIKA SikaCeram - 200FLEX - White - 5kg

All-purpose indoor and outdoor tile adhesive (C2-ET-EG) - SIKA SikaCeram - 200FLEX - White - 5kg, is a very low dust emission tile adhesive for the installation of ceramic and natural stone coverings up to 3600cm2, for new and renovation works. Advantages : Very low dust emission during the preparation of the mixture. Adhesive mortar classified C2-ET/EG. Can be used for interior floors and walls and only for exterior floors. Suitable for use on concrete substrates, paving, screed, cement-based coatings, cellular concrete, wood panels, old tiles indoors, old linoleum or PVC flooring, SikaLastic 850W, cement coatings and concrete in swimming pool basins. Features : Maximum tile size: 60cm x 60cm (3600 cm) for floor and 46.5cm x 46.5cm (2200 cm) for walls Operating temperatures: + 5 to + 30C (product, environment, support) Curing time: 3 min Maximum glue thickness: 10 mm Practical operating time: 3 hours (at +23C, 50% RH) Open time: 30 min (at +23C, 50% RH) Adjustment time: approx. 20 min (at +23C, 50% RH) Time before grouting: minimum 12 hours at +23C Putting back into service: time after grouting (depending on temperature conditions and the grouting product used): 24 to 36 hours (pedestrian traffic) Colour : White Packaging : 5kg Reference : 637424 Packaging : 1x Tile adhesive all tiles inside and outside (C2-ET-EG) - SIKA SikaCeram - 200FLEX - White - 5kg Delivered in its original packaging Tips : The substrate is prepared in such a way as to be clean, healthy, free of dust and loose parts that are not adherent or that could impair adhesion. In particular, it must be free of traces of release agents, curing agents, grease, laitance, plaster, etc. The substrate is moistened beforehand if necessary (application on a highly absorbent substrate or one that has been exposed to the sun, in hot weather). The surface must not be damp and must be free of any film or puddle of water on the surface during application. Mix with clean water to the desired consistency using an electric mixer at low speed (about 500 rpm) until a homogeneous paste without lumps is obtained. Mixing rate: approximately 28%, i.e. 6 litres of water per 25 kg bag, and 1.2 litres of water per 5 kg bag. Ripening time: 3 min. Prepare in advance only the quantity of product that can be used, taking into account the practical duration of use, open time, ambient conditions and the speed at which the flooring is to be laid. Spread the adhesive mortar on the substrate with a trowel or smoothing machine, then adjust the thickness with a notched spatula (choice of teeth according to the size of the flooring and the flatness of the substrate; (see product instructions). In the case of double gluing, coat the back of the element to be glued with a thin layer of adhesive mortar (1 to 2 mm). Maximum thickness of adhesive: 10 mm. Within the open time limit, lay the covering on the glued substrate and press or beat it strongly to expel the air and obtain a good transfer of the adhesive mortar. Clean the flooring with a sponge as soon as it is laid. Use SikaCeram Joint Fine, Large or Flex.