Tile paste adhesive for tiles and facing plate (D1-ET) - SIKA SikaCeram Basic - Ivory - 15kg

Tile paste tile adhesive for tiles and facing board (D1-ET) - SIKA SikaCeram Basic - Ivory - 15kg, is a ready-to-use adhesive used for interior walls for the installation of ceramic and similar coatings in new and renovation projects. Advantages : Adheres to concrete, cement-based plasters, plaster-based plasters, plasterboard partitions, terracotta tile, plaster tile and aerated concrete partitions. In wall installation, the surface mass is legally limited to 30 kg/m. Classified D1-ET i.e. normal adhesive with extended open time and slip resistance. CE marking according to NF EN 12004 Features : Operating temperatures: + 5 to + 30C (product, environment, support) Open time: 30 min (at +23C, 50% RH) Adjustment time: Approx. 20 min (at +23C, 50% RH) Maximum glue thickness: 3 mm Time to seal: 24 to 72 hours, depending on temperature conditions Consumption varies according to: the surface (flatness, roughness), the type of coating (size, relief, water absorption/porosity), the gluing method (single or double) and the spatula used. It varies from 3 to 5 kg per m2. Colour: Ivory Packaging: 15kg Reference: 461631 Packaging : 1x Tile paste adhesive for tiles and facing plate (D1-ET) - SIKA SikaCeram Basic - Ivory - 15kg Delivered in its original packaging Tips : The substrate is prepared to be clean, sound, dust-free and free of loose or sticky parts. In particular, it must be free from traces of demoulding products, curing agents, grease, laitance, plaster, etc. The substrate is moistened beforehand if necessary (application on a highly absorbent substrate or one that has been exposed to the sun in hot weather). The substrate must not bleed moisture and must be free of any film or surface water puddles during application. Glazed plaster plasters must be scratched and then dusted. Spread the product on the substrate using a trowel or a smoothing machine, then adjust the thickness with a notched spatula (choice of teeth according to the format of the coating and the flatness of the substrate (this is referred to the consumption table in the product manual). In the case of double gluing, coat the back of the element to be glued with a thin layer of adhesive. Maximum glue thickness: 3 mm. Within the limit of the open time, lay the coating on the glued substrate and press or beat it strongly in order to drive out the air and obtain a good transfer of the adhesive mortar. Clean the coating with a damp sponge as soon as it is applied. Finish the finishing joints with SikaCeram Fine, Wide or Flex Joint.