Under water coating (on cartridge) - Wenco

Manufacturer: Wencon
Be the first to review this product
Manufacturer part number: UNDERWATERCOATING(ONCARTRIDGE)
Vendor: ConceptSRP
€192.00
i h
WENCON UW Coating is an abrasion and corrosion resistant two - component epoxy, that will adhere and cure on dry, wet as well as submerged surfaces. Suitable for touch - up repairs on superstructures and pipings in general. 100 % solid and solvent free coating, capable of building up to 500μm thickness in one layer. WENCON UW Coating can be applied on surfaces where it is not possible to obtain a 100 % clean and dry repair area, in splash - zones as well as underwater.
Products specifications
ColourColors Orange (most colors are available9
Detailed SpecificationsMixing: Component A and Component B are combined in the static mixer nozzle that is screwed on to the cartridge before application can begin. Discard the first 1 cm, of the product until product is evenly coloured, and begin application. If the product has cured, replace the nozzle with new static mixer nozzle. Application: Apply using a brush or spatula, single or double layer.
ApplicationPHYSICAL PROPERTIES Consistency: fluid Mixing ratio vol. A:B = 2:1 (volume) Apply with: spatula/brush Potlife at 20˚C 20-35 min. Curing time: 8 - 18 hours Machinability: yes Hardness: shore D 79 Tensile strength Rcrack: 37,50 N/mm2 Compressive strength Rcrack: 133 N/mm2 Compr.strength modulus of elasticity: 3.117 N/mm2 Shear adhesion: 31,90 N/mm2 Adhesion to steel: >7,5 N/mm2 Specific volume: 535 cm3 / kg Dielectric strength: 10 KV/mm Shelf life: 36 months
0 review(s)
0.0 0
Write your own review Close
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
*
*
*
Only registered users can write reviews