Waterproofing of concrete block foundations - SIKA Igol Agglos - Black - 25kg

Manufacturer: Sika
Manufacturer part number: 164906
GTIN: 7612894669381
€182.88
i h
SIKA Igol Agglos - Black - 25kg, is a stabilized bitumen emulsion designed to protect concrete against light chemical aggression and to waterproof very rough-looking buried foundations. Advantages : Can be applied directly on porous substrates: agglos, cinder blocks or aerated concrete blocks. Easy to apply with a trowel. Adheres to concrete, mortar, stone, brick, wood. Does not flutter. Do not earthenware. Waterproof. Can be applied in 2 coats Features : Density: about 1 Application temperature: + 5C and + 30C Consumption: Depending on the roughness of the substrate: from 1.0 kg/m to 2.5 kg/m for the 2 diapers. Drying time: In rainy or foggy weather, protect Igol Agglos until it is completely dry. In closed environment, provide effective ventilation to accelerate drying. Dust-free: 1 to 3 hours (to see if the product is dust-free, Run a wet finger over Igol Agglos about 1 hour after application. If it does not leave any black traces on the finger, it is dust-free) / Out of water: 10 to 24 hours / Total drying: 2 to 5 days. Colour: Black Packaging : 25kg Reference : 164906 Packaging : 1x Waterproofing of concrete block foundations - SIKA Igol Agglos - Black - 25kg Delivered in its original packaging Tips : SUPPORT: The supports will be at least 10 days old. The supports must be clean, sound and free of loose parts. In particular, they must be free of traces of oil and grease. Porous surfaces should be moistened beforehand. Gravel nests must be levelled with Sika Monotop repair mortar. Masonry should be carefully repointed with Sika Monotop repair mortar. APPLICATION : The Igol Agglos coating is applied at least 15 cm above the finished level of the exterior floor. Igol Agglos is applied with a notched trowel, tightly, in 2 coats: the first coat is applied from bottom to top with the notched side of the trowel, the second coat, applied with the smooth side of the trowel, fills and covers the grooves left by the first coat. Apply the second coat in the same direction as the first, so as not to trap air between the two coats. Wait for the first coat to harden before applying the next one, i.e. about 1 to 4 hours at 20C depending on the ambient humidity. The total thickness of the coating must not exceed 3 to 4 mm, with a minimum of 2 mm at any point, in order to achieve proper drying.
0.0 0
Write your own review Close
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
*
*
*
Only registered users can write reviews