Waterproofing plaster for foundations, cellars and basements SIKA Foundation plaster - Grey - 25kg

Waterproofing plaster for foundations, cellars and basements SIKA Foundation plaster - Grey - 25kg, is a ready-mixed mortar used for waterproofing foundations, buried or semi-buried walls, walls, bases, cinder blocks, banch agglos and interior walls of garages and cellars from the outside. Advantages : Can be applied directly to masonry, concrete and cinder block foundations. Applicable indoors in non-inhabitable premises such as garages, cellars, etc. Impermeable to water Excellent adhesion to the substrate Aesthetics: cement grey colour Fast hardening allowing for filling in the shortest possible time Features : Density: approx. 1.3 / fresh mortar: approx. 2 Grain size: from 0 to 0.5 mm Temperature: from + 5C to + 30C Consumption: 2.5 to 3.0 kg /m for 2 coats applied by hand, in a single application layer in mechanical application. Practical time of use: +5C = >2h / +20C = 1h20 / +30C = 45min Setting time and minimum delay between 2 coats: +5C = 7h / +20C = 3h30 / +30C = 45min Waiting period : Dust-free: 1 to 3 hours, (to see if the product is dust-free, run a damp finger over the Sika Foundation Coating approximately 1 hour after application. If it leaves no black streaks on the finger, it is dust-free) / Dry: 10 to 24 hours / Thoroughly dry: 3 to 7 days. Recovery time : Wait for Sika Foundation Coating to dry completely before backfilling: 7 days at + 5C / 3 days at + 20C Color: Grey Packaging : 25kg Reference : 152712 Packaging : 1x Waterproofing plaster for foundations, cellars and basements SIKA Foundation plaster - Grey - 25kg Delivered in its original packaging Tips : SUPPORT: The substrate must be clean, sound, free of dust and loose parts that are not adherent or that may affect adhesion. In particular, it must be free of traces of oil, grease and curing products. The surface to be treated must be wetted without bleeding before application of Sika Foundation Coating. APPLICATION : Mixing can be done by hand, with a concrete mixer or with a propeller mixer, until a homogeneous mortar of creamy consistency is obtained. Manual application: Application is done with a hard brush, glue brush, broom or smoothing machine, in two thin coats. Mechanical application: The application is done by spraying in a single layer. Finishing is done by floatation. In order to protect the covering from impact during backfilling which could damage it, it is advisable to install a protection type Sika Protection Foundation. Use Sika products with care. Before use, please refer to the manufacturer's product manual available on the sika.co.uk website.