Waterproofing SIKA Sikagard Protection Sol MAT - 5L - To be used before 08/03/2020

EXPIRY DATE: 08/03/2020 Waterproofing SIKA Sikagard Protection Sol MAT - 5L - To be used before 08/03/2020, colourless impregnation in aqueous phase ready for use. Advantages : Improvement in waterproofing by the penetration of a polymeric resin into the free interstices of the material Surface protector and hardener, improves resistance to penetration of oils and greases Non film-forming: penetrates the substrate Colourless and matt after drying, retains the natural appearance of the substrate. Features : Appearance: Liquid Colour: White / becomes colourless and matt after drying Packaging : 5L canister Density: approx. 1.1 Maximum grain size: 0.2 mm Consumption: depends on the roughness and porosity of the substrate. It is of the order of 0.20 L to 0.25 L /m. Approvals / Standards: Declaration of performance (CE mark) according to NF EN 13279-1:2005 Reference : 460502 Deadline for use : 08/03/2020 Packaging : 1x SIKA Sikagard Floor Protection MAT Waterproofing - 5L - To be used before 08/03/2020 Delivered in its original packaging Tips : SUPPORT Mortars must be sufficiently hard and absorbent to allow penetration of the product. Ensure that the substrate to be treated is sufficiently porous to allow Sikagard Floor Protection MAT to penetrate. Carry out the following absorption test: place a few drops of water on the surface to be treated. If they are quickly absorbed (less than 10 s): the support is sufficiently porous, it can be waterproofed normally. If they are slowly absorbed (from 1 to 10 min): the support is not very porous, the support can be waterproofed in a thin layer. If water is not absorbed, the substrate is too "closed" and cannot be waterproofed. The substrate must be clean, healthy and dry, free of dust, oil, grease, laitance, curing agents and any substance that may impair adhesion (such as plants). Mosses and lichens will be treated and removed a few weeks beforehand with Sikagard Stop Algae PRO or Sika Stop ALL in 1. If necessary, the substrate should be pre-cleaned with a facade cleaner (Sikagard Cleaner or Sikagard Cleaner Concentrate) and a high pressure washer. The best penetration results will be obtained on dry and highly absorbent substrates. Substrates must be dry on the surface with no moisture stains. APPLICATION Sikagard Floor Protection MAT is applied in 1 uniform coat, by roller or brush. A low-pressure sprayer can also be used. Make sure to impregnate the support well while avoiding overconsumption. Protect from rain for 24 hours after application. Drying time / restart time: 12 to 24 hours, depending on ambient temperature and humidity. LIMITATIONS Can make some floors slippery. A preliminary test is recommended Treating substrates in dry weather Avoid excessive consumption. A layer that is too thick can lead to unsightly disorders (whitish halos, tiling, peeling). Protect surfaces from rain during the drying period.