Waterproofing supplement for swimming pool SIKA Coating Swimming pool - Foam white - Kit 18,48kg

Waterproofing supplement for swimming pools SIKA Coating Swimming pool - Foam white - Kit 18,48kg, is a pre-dosed micro mortar used as a waterproofing supplement for the interior lining of wall and floor pools. It is applied with a float, roller or brush. Advantages : Applicable on wet surfaces, but not dripping Possible colouring Excellent adhesion to concrete and mortar Waterproof Permeable to water vapour, it allows the support to breathe Good chemical resistance to common pool water treatment products Can be renovated over time with a new layer Can be used with tiles glued with SikaCeram-205 Features : Density: about 1.5 Temperature: from +5C to +30C Practical use time: about 1 hour at 20C Waiting time between 2 coats: 6 hours minimum at 20C Consumption: 1 kg/m in 2 layers, i.e. 1 kit of 6.16 kg for approximately 6 m. It is important to respect this consumption. The quality of the coating and its good resistance over time depend on it Colour: Foam white Packaging: the kit contains 3x 1 canister of 2L and 3x 1 plastic bag of 4,16kg Reference: 720 Packaging : 1x Swimming pool waterproofing supplement SIKA Coating Swimming pool - Foam white - Kit 18,48kg Delivered in its original packaging Tips : SUPPORT : The substrate (concrete, screed or plaster) must be clean, sound, dust-free and free of traces of oil or any substance that may affect adhesion, and must have a surface cohesion of at least 1MPa. The plaster and screed under Sika Coating Piscinene should not be smoothed but talocheted in order to have a good adhesion. If the substrate is very closed, sandblast before application. The substrate must be moistened to refuse the day before and re-wetted the day of application. If the temperature is close to 30C, humidify as the work progresses. APPLICATION : It can be applied with a brush, a roller with medium-length bristles or a platter as a first coat on the walls. Special points will be treated with a brush (angle, fittings, etc.). A minimum of two coats is required. Waiting time between 2 coats: 6 hours minimum at 20C. It is necessary to moisten slightly before applying the second coat. As a renovation layer, on a clean and healthy surface, after humidification, apply a coat with a short-haired roller at a rate of about 400 g/m. Use Sika products with caution. Before use, please consult the manufacturer's product manual available on the sika.com website.